To begin the hardware setup, you will require the below items.
|
Quantity* |
Item |
|
1x |
iPad |
|
1x |
Case |
|
1x |
Lanyard |
|
1x |
Support Flyer |
*The quantities will vary depending on how many devices the Client has requested.
1. Prepare the iPad Case
Tools:
- Case Install Hook
- Rectangle Install pick
| Unpack the iPad case and the accessories from the plastic sleeve. | |
|---|---|
|
|
| Dismantle the iPad cover and prepare to install onto the iPad | |
|---|---|
|
1. Remove the rubber layer. Lift and pull the Teardown tab outwards to start. Or use the blue pick provided with the case. |
|
|
|
|
|
2. Pry the tabs slightly on each side to unclasp the plastic frame. Remove the How-to guide already inside. |
|
|
|
|
|
3. Remove the blue film (if applicable) and the residual glue from the front portion of the frame. |
|
|
2. Install the iPad Case
Before installing the case onto the iPad note down the serial number of the iPad. Write the serial number onto a sticky pad which will then be used to label the cased iPad.
The serial number can be found on the back of the iPad, at the bottom.
| Install the case onto the iPad |
|---|
|
1. Centre the tablet facing upright on the bottom portion of the green frame. |
|
|
|
2. Re-clasp the top cover above the iPad. |
3. Re-install the rubber cover to the green frame. |
|
|
|
3. Installing the Lanyard
|
1. Remove the lanyard (3) and the tools (1 & 2) from the sleeve. |
2. Unclip the two buckles from the shoulder strap. |
|
|
|
|
3. Thread the two unbuckled ends of the shoulder strap to the holes on the back of the iPad case. Use the blue hook for assistance. |
|
|
|
|